12V15CH RF wireless remote control switch system 15receivers&1 transmitter independently Toggle/Momentary/Latched Adjustable
This product is typically applied to the multi-channel electric doors and windows, ordinary electronic lock, switch, electric garage door, window, hoisting equipment ,industrial automation and control, all kinds of anti-theft alarm ,security and other fields .The remote controller supports the use of forming a complete set of wireless intelligent remote control system .It has a wide range of uses.
Operating Voltage: DC12V
Operating Current: ? 6Ma
Operating Frequency: 315,433 MHz
Operating Temperature: -40°C ~ +80°C
Receiver Sensitivity: ?-105dBm
Output Voltage: AC / DC (optional)
Output Current: ? 10A
Code : Learning code .(jog/Non-Latched .inter-lock/Latched .self-lock /Self-Latched )
Size: 48.2 x 32.8 x 15mm/1.89 x 1.29 x 0.59in(L x W x H)
Wireless Remote Control
Transmitting distance :20-200M
Transmitter : Waterproof
Receiver : with the cuitcase cover
Working voltage DC12V
Operating Current 16MA
Operating frequency 266-433MHZ
Transmitting distance: 180 meters
Encoding way: Fixed code, learning code, rolling code.
IC chipset: PT2260 ,PT2240,EV1527, HCS301.
Size 55 * 30 * 13.5 mm
Output Working Way
Self-locking: Connect the jumper 1 with the cutting out cap. ( Self-locking control mode:Press the switch is on the load, press the same switch again is to disconnect the load.Need one channel switch and a one-button remote controller.)
Jog---The cutting out cap is not occupied, jumper 1 and jumper 2 do not connect either.Press the switch is on the load ,loosen is to disconnect the load. Also need one channel switch and a one-button remote controller.)
Inter-lock------- Connect the jumper 2 with the cutting out cap (Press one switch is on the load , press another switch is to disconnect the load . (Need one channel switch and 2-button remote controller.)
2 Channel is self-locking and 2 channel is jog ,connect the jumper 1 and jumper 2 with the cutting out cap .)
Please notice that there is a 4CH receiver and a 4-button transmitter, you can choose these working ways :self-lock , jog or self-lock and jog together.
Learning and Remove Method
1 .There is a learning button on the control panel of touch switch, the button is used to learn and remove the code.
2 .Press and hold the learning button for three seconds.When the indicator light flashes,we enter the learning state. Press any key on the remote controller to emit signal, the light flashes two times and off .It means you learn it successfully.
3 .It can learn more than 12 PCS 2262 or 1527 chip with the different code wireless remote controller.
4. Delete remote control method: hold down the learning button for about 8 seconds, the indicator light turns on to off, then the code you learned before will be deleted..
here is the 15 receiver and 1PCS 15Button transmitter , so it can be 1 buton to 1CH , so you can choose all the output state as you like