The Turnigy Monster-2000 is based on an all new powerful microprocessor.
The new CPU means ultra fast sync timing, crisper throttle response, extremely low resistance and high voltage overheat protection.
Extremely low resistance
200A continous(230A surge)
Up to 38cells NiMH/NiCad or 2-12 Lipo cells
High rate adjustable switching (PWM:12K Hz/18K Hz/24K Hz)
Programmable low voltage cutoff
Programmable cutoff types(soft cutoff/hard cutoff)
Programmable brake type(disable/soft brake/hard brake)
Time advance programmable (low/standard/high)
Programmable current limiting(very sensitive/standard/insensitive/disable)
Governor mode(low rpm governor/high rpm governor)
Programmable Constant Power startup type(very soft start/soft start/fast start)
Thermal Protection(100 centigrade)
Apply to most of inrunner and outrunner brushless motors.
No complex programming, auto adapt work mode.
Safe"power on" arming program ensures motor will not accidentally turn on.
Auto shut down when signal is lost or radio interference becomes severe for more than 3 seconds .After radio connection has been reestablished, moving the throttle to the lowest position can restart the motor.
The ESC is disabled when the voltage is over 51v at power-on.
Cont. Current: 200A
Burst Current: 230A
Battery: 4-12 Cell Lipo / up to 38 Cell Ni-XX
This is an R/C plane/heli only ESC. Do not attempt to use it to power car, buggy, skateboard, go-kart or similar machines. The programming logic is only designed for R/C Planes and Heli and will burn if applied to other devices.
200A Microprocessor-controlled high-voltage brushless speed controller for drive motor C12080 AND C12090 following: