500W Grid Tie Power Inverter,Dump Load Controller,For 3 Phase Wind Turbine,AC/DC10-30V AC 220V,(190v-250vac)
Seller Promise:
500W GRID TIE POWER INVERTER FOR WIND with DUMP LOAD CONTROLLER
AC/DC10.8-30V AC220V 230v 240v
3 phases AC input , build in dump load controller.
************************************************
Why choose PI-500GWAL ? ? ?
Build In Rectifier
Build In Dump Load Controller
Build In High Wind Protection
Pure Sine Wave
Input:AC/DC10.8V-30V Output:AC220V
Weight: 4 kg
Grid Tie Inverter for Wind Turbine
Build In Rectifier
Build In Dump Load Controller
Build In High Wind Protection
Preface
The grid-tie inverter can transfer wind energy from wind generators directly into the home grid using no extra equipment. It can be connected to any outlet(conventional network) in the home. The grid-tie inverter controls the phase and the frequency and voltage of the power generated by the wind generator. It produces a pure sine-wave and matches that of the grid.
This model grid-tie has build in bridge rectifier, it has a high voltage protection function, when the wind is too big, and the dump load controlling system can’t keep the output voltage from the wind turbine, the controller will disconnect itself from the wind turbine, so it is very safe to be used.
Layout
| No. | PI-500GWAL |
| Normal AC Output | 450W |
| Maximum AC Output | 500W |
| AC Output Voltage Range | 190V-260v |
| AC Output Voltage Range | |
| AC Output Frequency Range | 46Hz ~ 65Hz |
| Total Harmonic Distortion (THD) | <5% |
| Power Factor | 0.99 |
| AC/DC Input Voltage Range | 10.8V ~ 30V(the test point is at the output of the |
| Peak Inverter Efficiency | 92%(The consumption of the rectifier is not calculated.) |
| Standby Power Consumption | <1.5W |
| AC Output Waveform | Pure Sine Wave |
| Over Current Protection | Yes |
| Overheating/Thermal Protection | Yes |
| Reverse Polarity Protection | Yes |
| Island Protection | Yes |
| Stackable | Yes |
Recommend Dump Load Resistor 5 ohm/500 watt
Shipping:DHL TNT EMS
