PLEASE READ ALL DIRECTIONS FOR BEST RESULTS:
Step 1. Preheat iron to 325F(or 150-180C) for at least 5 minutes.
Step 2. Lay garment on flat, heat resistant surface. Place a thin layer of cloth inside shirt, positioned where motif will be.
Step 3. Work out any wrinkles with your hand or iron garment lightly.
Step 4. Take your motif out of the package and carefully peel away WHITE backing.(If any rhinestones or studs shifted as you peeled the tape, take a tweezers and reposition on sticky tape).
Step 5. Place motif (with clear sticky paper) on garment where you would like it to be. Make sure you like the position, if not, peel off and reposition. DO NOT take crystals or metal studs off sticky paper, you will iron directly over this clear sheet-don’t worry, it will not melt.
Step 6. Place iron directly onto clear film for approximately 15-18 seconds applying light to medium pressure.
Step 7. When done, take a towel and rub motif upon removing iron. Quickly remove cloth from inside of shirt.
Step 8. Let motif cool for about 5 minutes before removing sticky tape. If a few studs or rhinestones did not adhere to shirt, reapply heat to them separately.
Step 9. Enjoy the sparkling garment now!
1. Do not use a steam iron for apply.
2. If you have a motif larger than your iron covers, iron one section at a time. Moving iron back and forth is not recommended and may cause your design to shift. To get a better result for larger motif, a heat press machine is recommended.
3. Please make a test for the best time and temperature before bulk apply.