K10A Wall Mount Sensor Switch/Infrared Switch / Pir Sensor Switch

Product Description

K10A Wall Mount Sensor Switch/Infrared Switch/Pir Sensor Switch

 Product Features:

1. Automatic body sensors: one to light, people take the lights out;

2. Installation simple and convenient, safe saving, saving more than 85%;

3. Using non-contact electronic switch, no spark, do not interfere with other electrical appliances;

4. Exceptionally strong anti-interference ability, standby power, long service life, and can effectively extend the life of the load;

5. Wisdom delay in detecting the load within the bounds of sustainable work.

6. The day off, energy-saving choice. 

use:

Install this product before determining the application with the range (distance. Angle) position, the product detection range of up to 5-8 meters, the detection angle of 115 degrees. 

Note:

1. This product is suitable for light or exhaust fan, etc.;

2. Just pass on the power supply, the lamp will flash 1-3 times, then about 30 seconds after the light to work (no walking detection zone);

3. White film is the infrared receiver lens, do not scratch, stain if you use a clean cotton cloth graze, is strictly prohibited by wear;

4. This product is relatively straight horizontal induction effect of good sense;

5. This product can not be directly used unprotected outdoor exposure in the open air environment;

Technical parameters:

1. Working voltage: AC200V-250V 50Hz-60Hz

2. Load Type: 25W-200W

3. Detecting distance: 8 meters

4. Detection angle: 115 degrees

5. Delay time: 40s -200s