Motorcycle decorative accessories car electric car conversion parts 3M 3M reflective stickers reflective stickers affixed eyebro

Product Description

The small car with a transparent transfer film paste dried paste method
 
   Need tools: a clean rag, scraper, or a variety of membership cards, bank cards

   The first step: clean the body and keep the body dry and
   The second step: the transfer film (reflective paste paste in the transparent film), together with car stickers with lift; under normal circumstances, the side of the paste slowly, while tools evenness, while Jiedi paper.
Of course, if the length and width of the car stickers are less than 10 cm, but also the transparent transfer film and the sticker removed all the paste. But be careful not to accidents or fall on the ground sticky adhesive from dust.
   Step Three: If you encounter or collision of the door handle the situation according to the actual sticker and cut the excess part of the package are set out in or out.
   Step Four: Use a clean cloth or scraper in the transfer film on the rubbing or scraping repeatedly forced a few oblique; until there is no bubble car stickers, and transparent transfer film can be torn off.

2, a transparent transfer film with a large car stickers wet paste method

   Need tools: rags, containers such as watering flowers with watering can, scraper, or a variety of membership cards, bank cards

   The first step: clean the body and keep the body dry.
   Step two: the amount of clean water into the watering containers and add a small amount of detergent. Recommend the use of pure water to reduce impurities
   The third step: going to paste the stickers in the stickers on the back of the body parts and even sprinkler. Stickers to reduce viscosity, easy to adjust the position
   Step Four: Determine the location that you need posted. The side of the paste slowly, while gently scrape with a tool and squeeze out the water, while Jiedi paper.
   Step five: If you encounter your door handles or the crash of the sticker according to the actual situation and cut the excess part of the package are set out in or out.
   Step Six: appropriate adjustments, to determine the correct location of the graphics in general, the force repeatedly scrape the water and bubbles. REMOVED transparent transfer film.
   Step Seven: Do not let the car body stickers and any separation or protrusions.
   Eighth step: try to make car stickers in the water dry, dry conditions can be moderately heated.

3, sticker removal method

   Non-reflective material stickers, direct hand in the room temperature can be easily removed. For larger stickers tear when a certain not too hard, and control your speed, from one side to the other side slowly opened.

   For the paste for some time made use of reflective materials, stickers, if you need to remove it recommended heating method. Can first use the heat gun (or hair dryer) to heat entire sticker. Do not immediately heated hands to tear, and other cool little sticker surface after carefully peeled off by hand can grasp a good temperature to remove reflective relaxed a key factor. Torn off without leaving adhesive residue after the reflective material will leave little residue, you can use Bo Youqing lotion and cleaning agents remove self-adhesive, can also be time for the car wash car wash to clean. Should not not use hard objects such as knife the hard scratch sticker, so as not to scratch your car's paint. If the sticker affixed to the glass surface, be sure to pay attention to control the temperature, especially in the winter. In order to avoid local heating of glass burst damage occurs to your body.