Plug in Digital Room Double road temperature Controller

Product Description

WST-K2 type Double road electronic temperature controller introduction

The function of each button is clearly, through the relay hige to achieve automatic control, temperature controller will according to the changes and automatically shut off or start the control equipment.

1. Technical specifications:

2. The parameters set operation:

• After power instrument by 0-9 in turn shows, detection display is normal, enter the system state after work, display measured values, not changing the set, the original record the data set with automatic control operation.
• Change is accused of humidity setting: It is energized, long press SET key, access to menu mode, according to the corresponding parameters on the adjustment, press " increase " or " reduce " button to change the SET value, " increase " is used to increase the temperature setting, " reduce " used to reduce the temperature setting, Press the "SET" save Settings of data, then the temperature controller to return to control operation , the system default 10 seconds to be automatic memory to return working state.
• Of actual use please do not set the limit higher than the upper.
• Temperature sensor short-circuit, open circuit fault tip Err.

3. Installation: instrument temperature must be held at around -5degree C  ~ 65degree C , the instrument must be placed in no damp and high pressure situation, and ventilation to easy to heat dissipation. 

4. Wiring: put the device that need to control inserted in a socket, the power supply must match the manual of the instrument.

5. Parameter (the first group on the left, the right is the second group):

Note: HC heating/cooling state switch data

00 = heating,01= cooling