Retail and Wholesale!Decorative Shells Stickers Home 60*43CM

Product Description

         Size: patchwork picture:60*43CM;  actual results Photo:may need to be adjusted according to the size of  place site

 

 

     

 

We recommend that you use the product before you pick a scrap with the transfer film under the corner of the wall stick performance test to determine the powder can not afford to not take off, no effect after the paste. Through our many experiments and a large majority of customer feedback that can be used normally. The general needs of the newly renovated walls can be used after 2-3 months, please test before use is still attached. As a result of wall paint off the wall as a result of operational errors or damage, shall not be responsible for!
 
Preparation Tool:
Scissors, razor blades, bank cards, transfer film, etc.
 
Steps:
Wall Stickers simple operation. Identify the location of the first post of designated and recommended by two people with one possible means, and paste the following completed:
1, the first part of the pattern of extra white space outside the cut off, so easy to paste;
2, the transfer film after removing the backing paper attached to the pattern, such as not completely glued to the transfer film, you can pick off with a blade supporting. Zaiyong bank card scraping back and forth on the transfer film several times, so that patterns better stick together with the transfer film;
3, the pattern attached to the specified location, and evenness from the air bubbles by hand corner, where there are patterns with hand pressed smooth. (Attachment: first transfer film in the paste can be fixed in a corner of the wall, then slowly down along the direction of the transfer film on the wall, and then bank cards by the middle of the pattern repeated around the direction of scraping a few so better stick to the wall pattern);
4, the transfer film to tear away from the wall, the hand according to pattern, parallel to the wall from the corner as far as possible, try to slow, do not tear off the pattern associated. (Note: The transfer film can be repeatedly used)
5, you're done! Original drab wall full of fashionable immediately.
 
Note:
1, before the operation, we recommend that you cut off part of the corner transfer film line and select the foot of a wall under the wall of the performance test, if the wall easily glue the powder transfer film can be stuck in the towel a few more to less viscous. Also recommend that you try to empty the transfer film cut to avoid excess part of the damage the wall. Of course, some extra photos can also be cold lamination.
2, this product can be pasted on walls, glass, tiles, switches and other places. If instructions are not enough details, Please refer to the graphic tutorials, be sure to understand clearly before you start. To avoid affecting try not to peel off the wall suggestions. To tear, can make use of hair dryer can be stripped while blowing edge tear, tear the wall next to the hand as much as possible.
3, we care as much as possible into a unit designed format, which is more convenient to paste. Also recommend that you cut into small pieces and effect diagram to separate the light paste. When affixed to the larger pattern is not smooth because of the emergence of bubbles, can be smoothed by hand needle to break the bubble.
4, due to the light, color, computer and other reasons, the effect is real picture may go astray and products, the specific color of your subject to physical products.
5, affected by the material, width and height of more than 1 m is required, such as stitching, please refer to the specific effect of pictures to paste.