Product Description

This export quality 100% comfortable long life!
The brightness of the lamp can compare with other sell higher-priced products!
Some buyers said lamp test is not bright, it is on the order of points and the positive and negative, if not light will, in turn, it is good to go:) base have two could contact if not bright upon the wire position, the lamp base with you on OK!
Store, each lamp will be strict test before shipment, buyer can totally rest assured to buy!
Product name: T10 5 5050 three core SMD leds
Product voltage: dc 12 v (that is, the average output voltage of the car)
Product use: wide lamp, reading lamp, license plate lamp, car ceiling lights, door lights, tail lights, side lights, and so on
Irradiation Angle: 360 degrees
Products are light color: white, pink, yellow, red, blue, green, light purple
Product size: length 29 mm, partial port 9 mm, maximum diameter of 12 mm
3 chip manufacturing, fine handwork this product synchronization in Japan sell like hot cakes!
Suggest to buy a car 4 to 8
Has features:
1, the product USES the SMD chip, ultra-thin strip shape design makes installation fit better, illumination is more uniform and avoid the disadvantages of point sources of irradiation width is bad; Products suitable for 10-13 v voltage. This SMD product divergent light source, a wide Angle light, Gao Liuming degrees;
2, light without delay, high optical purity, color and strong penetration;
3, using LED light-emitting diodes, power consumption is small, can better protect car circuit;
4, LED no filament, good heat dissipation, small current, calorific value, small vehicle circuit to oxidation;
5, strong seismic force, low temperature rise, is a new generation of revolutionary solid-state light source;
6, suitable dc 10 to 13 v.
Note: the product
Without conversion circuit, directly replace the original traditional glass bulb, pay attention to the original bulb temperature is higher, prevent burns!
When installation reference product dimensions refer to the installation location space size, careful pressure, don't squeeze the LED chip, so as to avoid damage. Leds have positive and negative polarity, not bright, turned about to installation;
The LED characteristics:
1. The traditional tungsten filament bulbs can directly replace the original car;
2. LED high purity, no chimney filters, optical wavelength error was less than 5 nm
3. The LED light up without delay, the traditional tungsten filament bulbs were 0.3 seconds of delay.
4. LED low power consumption, to the traditional light bulb the same luminous brightness, power consumption is only 6% of the traditional light bulb, but also have the effect of power-saving fuel-efficient!
6. LED lights can make vehicle control circuit not easy oxidation, maximum load current of 0.1 A