Smarter Shopping, Better Living!
Godox RING48 is designed to fit Canon, Nikon, Sony (need a hotshoe adapter, not included), Pentax, Olympus, Tamron, Tokina and Sigma macro lens. Intended for close-ups, you can adjust this item to semi or full light to customize your lighting effects and control its direction.
YN-160 LED Pro Camera Camcorder DV Hot Shoe Video LightUS$ 63.16 - US$ 71.58/piece
1) Power Controller Installation
Attach hot shoe onto the camera hot shoe mount and rotate to tighten the hot shoe locker ring.
2)Installation of macro ring LED light head to the camera
6 types of adapter rings available to suit the camera lens: 49mm, 52mm, 55mm, 58mm, 62mm, and 67mm.
3) How to Use
A. Power Supply by Battery (2 AA alkaline dry batteries or rechargeable Ni-MH batteries)
Install the battery and switch the power controller to “BATT”
B. Power Supply by Charger
Insert the round plug of charger into the ‘DC3V’ of power controller and connect the other end with the DC power. Then turn the power switch of power controller to “DC3V”.
Warning: this charger is only used for LED light. Do not use it for the rechargeable battery. Please don’t leave the rechargeable battery in the power controller when it is being charged
Designed for macro-lens, the LED light could be used with other types of lens, but please take note the followings:
Some lens might turn after the installation of this macro ring LED light, which may affect camera focusing. Please use manual focus when apply this kinds of lens.
1)Clean the ends of battery to make sure the good connection.
To avoid battery explosion, fluid leakage or overheating, please use the same model and brand new two AA batteries, not to mix old and new batteries or different models for use.
2)Do not dismantle or drain batteries or put batteries in water or fire, which may cause explosion. Do not charge the batteries except lithium and cadmium cell.
3)Due to its high power consumption, we strongly recommend rechargeable batteries. If common 1.5V battery is used, the flash will not enough and the service time will be short.
4)Remove the batteries if you don’t use the lamp for a long time.
Voltage Range: 100-240V/50-60Hz
Electric Power Consumption: Approx. 5w (all light on)
LED Index: Approx. 15GN (all light on)
Power Rate: Semi Power/Full Power
Power Source: AA batteries×2 or DC3V
Working Hours: 1.5 hours with 1.5V alkaline batteries/1.0 hour with 1.2V rechargeable batteries
Weight of Ring Flash Body: 125g
Weight of Control Unit: 60g
Weight of Electricity Charger: 115g
Weight of Step Ring: 100g
Size of Step Rings: 49mm/52mm/55mm/58mm/62mm/67mm
(Please check with your lens manufacturer to determine size of filter threads)
1xLED Macro Ring Head