Digital Wireless Remote Control Light Lamp Switch Lamp one Way Light White FK-921











1. 3 Way Wall LED Light Remote Control Switch for 50 Meter
2. Tracking Notification Service
3. Fast Delivery
Outdoor Wireless Remote Control with 50ft. (15.2m) Range
RATING:110VAC/60Hz/10A/1500W RESISTIVE & TUNGSTEN
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condition:
(1) this device may not cause harmful interference,
(2) this device must accept any interference received, including interference that may cause undesired operation.
The user manual or instuction manual or unnitententional radiator shall caution the user user that changes or modifications not expressly approved by the party responsible for compliance could void the user authoritv to operate the equipment.
NOTES: This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interferences to radio communication.
However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferences to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is needed
4. Consult the dealer or an experienced radio/ TV technician for help
BATTERY INFORMATION AND REPLACEMENT
The Remote Control uses a volt CR2032 lithium battery. To replace, Slide off the battery cover on the back off the Transmitter.Lnsert a new CR2032 lithium battery, making sure to match up the +and polarity markings. To test, press the ON or OFF buttons to make sure the LED lights up. Slide the cover back in.Do not dispose of batteries in fire. Batteries may explode or leak.
CARTION:
1. Only use the batteries specified and be sure to match the +and polarity markings.
2. DO not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be used for a long time.
5. Do not dispose of batteries in fire . Batteries may explode or leak .As with all small items, these batteries should be kept away from children. If swallowed, seek medical attention immediately.
Lnstructions:
1Pulg the cord on the Remote Base into a grounded outlet.
2Pulg your electrical devices into the Remote Base . Be sure that your electrical device is powered ON.
3Use the buttons on the Remote Control to turn your devices ON or OFF.Each numberde On/Off button controls the controls
the corresponding receiver.(See image 1)









Important Notice:
1.Customs clearance can increase the delivery time if your package is held up by customs officials, We did not take the responsibility for clear custom in destination country.
2.Netherlands,El Salvador,Saudi Arabia,Venezuela,Greece,Lithuania,Bulgaria,Chile,Poland,Bolivia
These countries canot ship by "EMS" and "Shenzhen EMS" ,If you choose "EMS" we will seperate order and ship out by register airmail.Thanks!




