To make sure that you can use the product safely, please read the introduction seriously and keep it.
ELB seiries firing system is connected by the 220V current electricity to supply power, has product test and line road test function ,each group can ignite about 20 pieces.
1. product test(before you connect with the products)
a. firing system is connected by the 220V current electricity, the yellow and red indicator shows bright,and this product is normal; if there is any one isn't bright, it means this system can not use.
b. Press telecontrol button, the red light distinguish and the yellow one is more bright, it means the controller runs well.
2. using method
a. connect the firing system with 220V,the power light will be bright,turn on the power switch ,the power light bright
b. put the power swith to "off",another switch to "test",connect the products in series or parallel (in series is better).
c. line road test:put on the power switch, another switch to "test", connect the products in series, press the relative button on the board or of the remote,if the light of the test is bright ,it means the line road is normal, if the products are in parallel connection.(test way is the same as in series)
d. After testing is well-balanced, put the TEST switch on FIRE position, press the corresponding button (or press the corresponding button of control) to fire .
e. this kind machine can keep a little power,without 220V ,the machine can use,but the remote is invaid,after is keeped power use up,it need connect with 220V.
f.if the channles is more than 12,when you use the remote,put the button of the remote left,it control the channels of the area A,turn right control area B.