HID Telescopic Bulbs

Product Description

HID Telescopic Bulbs Function parameter
1) Power: 35W
2) Lumination:2500~ 3,500lm
3) Lifespan: 3500hours
4) Operating ambient temperature range: -40 degree~ +105 degree
5) Color temperature: 3,000K-30000k
6) Voltage: 70v~100v
7) wiring: high temperature-risitant, high voltage-resistant
8) Cover: crystal glass tube of UV-CAT anti-ultraviolet
9) Luminescence way: produced luminous by gases colliding

Color temperature and color
The color of bulb is expressed by color temperature:
3000k/Golden
4300k/Yellow White
6000k/Shallow Yellow
8000k/Blue White
10000k/Cambridge Blue
15000k/Blue Red
20000k/Pink
25000k/Mauve
30000k/Purple

instruction for installation
1.separate the headlamps(right & left)from your car after opening your car bonnet. if there is enough space for exchange, it is not needed to separate the headlamps from your car.
2.Open the rear cover of the headlamp and pull the installed halogen lamp out.
3.Drill a hole in the middle lf the rear cover of the headlamp with a 21mm hole cutter.
4.Take out the plastic cap of the HID bulb.(be careful not to touch the bulb.)
5.Put the HID lamp into the headlamp unit. ( caution: please confirm whether the installation of press spring has settled properly after installing the lamps. )
Caution: please check again whether the installation is proper after installing the lamps.
6.Connecting the wires-referring to the wiring diagram in the guide book.
7.Close the cap of the headlamp after fitting the rubber barking attached to the bulbs wire into9 the units cover.
8.Stick the ballast on the nearest place from the headlamp in the engine room firmly by using double-faced tape , cable tie and etc.
9.Connect the wire of the ballast with the wire of bulb.
10.Test whether or not the headlamps work properly.
*if both lamps dont light at the same time or flicker ,change the battery to more than 60Ah since it results from the lack of electric power; or add relays to bear more than 15A since it results from the lack of electric current.
*make sure to change the fuse for the headlight to at least more than 20A. If you use the fuse less than 20A,it tends to be out when the light turns on.
------------------------------------------------------------------------------------------
The Supereminent Features of HID Xenon Light
1.safety Instruction:Its unique safety design:Driving safely can be enhanced greatly for the light is equipped with shorp-circuit protection device,contra-pressure protection design.Therefore,the light has been in the favor of the automobile modification fans from Europe,U.S.,Japan,South Korea&Taiwan etc and adopted by BWM,BENZ&AUDI etc for the original assembly.
2.Output Luminance:3times the same as that of the halogen light:Usually,we use Lumen to describe the luminance.HID xenon light has a luminance up to 3,200 lumen while the halogen light about 1,000 lumen,therefore,the output luminance of the HID xenon light is 3 times the same as that of the halogen light.
3.High CT (color temperature:)The HID xenon light can have about 6,000K CT light.The so-called CT means that when the temp-erature of a standard matter heated up increases,the matter will have a light color change form from dark-deep red-yellowgreen white-white which is described with teperature taking the absolute tempertature K(Kelvin)as its unit.The light at 6,000K or so is absolutely white & little blue,which is close to the sunlight at noon& comfortable to out eyes.
4.10 times life as the common ones:Everyone encounters possibly the matter that the tungsten filament of the halogen light is burned down & the light thus goes off when in high heat.In contrast,the xenon light shines by means of a current equal to that used for a flashlight stimulates the gas to shine,as a result,no high teperature happens&the light can not be easily damaged!according to a research,even high quality, a halogen bulb can at the most last 400 hours while a xenon light can last 25,00 hours,which means that a xenon light can be used under a normale use condition for more 6 years.
5.1/2 power consumption as the common ones:General speaking, a halogen light in a vehicle factory can consume electricity 55~65W or so while an HID xenon light needs only 35W to support the luminance if working under the stability by a stabilizer.
6.Using UV-CUT crystal quartz glass,the HID xenon light can keep crystal forever!
7.Convenient installation & use:When installing,we need only use the bulbs in the discharge light group to take the place of the original halogen bulbs &then plug all cables attached into the sockets&stabilizer related.

product drowing