The Latest~! Raspberry Pi Starter Pack Starter kits discovery pi box pi cable leds breadboard Pi Cobbler Breakout Kit GPIOUS$ 38.95/pack
Pi case Colorful Building block pi box ,Factory price Pi Box for Raspberry Pi in stock!+3 pcs pure aluminum heat sink set kitUS$ 7.95/piece
10pcs Pi Box case for Raspberry Pi+30 pcs pure aluminum heat sink (not with paste) + 10pcs Heat Sink Compounds set kitUS$ 34.90/lot
10 pieces / lot
Enhanced version - cubieboard pi case new generation of shell Pi Box for Raspberry Pi+3 pcs pure aluminum heat sink set kitUS$ 18.89/piece
It is a good plastic box for Raspberry Pi, which can protect it with one of these snazzy plastic enclosures?. These cases protect the Raspberry Pi from things like rogue wires that might short it out while still allowing full access to the board! Simply snap the RPi into the bottom half of the enclosure, then snap the two sides together.
The enclosure provides slots to access the peripheral header, USB ports, Ethernet, SD card, HMDI, composite video, audio, CSI and JTAG connectors as well as feet and vents to ensure the board gets proper cooling and plus-shaped wall mounting slots. All of the status LEDs on the Pi are visible through the case thanks to light pipes embedded in the design. This is a really slick case and once you've gotten your hands on a Raspberry Pi, you'll want to snag one of these to put it in!
Package include: 1 * Pi Box for Raspberry Pi
3 * pure aluminum heat sink set kit
Notice:Box need your to assemble, but very simple, and then tear off the plastic protective film on the surface.
Before installing, tear up the surface layer of protective paper will be transparent and beautiful !
Because raspberry send the latest version (512M) USB port iron sheet than the old version (256M) slightly wide a little bit, thinking too small usb port of the housing, and is in fact not the slightest attention to the next order of installation can!
As shown below:
First step: the most important: usb port to install the baffle, slightly oblique point can be installed inside!
Step 2: installed on both sides of the panel (the only place not to pay attention to violence)
The third step: mounting plate (the easiest step)
Step 4: Install the cover (7) and sd the power baffle (8) (mounted baffle the place, do not like violence)