Microchip PICkit3 PIC KIT3 In-Circuit debugger/programmer for PIC microcontroller dsPIC PIC32 MCU Microcontroller
This is a high-speed and low-cost hardware debugger/programmer. It can be used for in-circuit debugging logic incorporated into each chip with Flash memory.
The MPLAB PICkit 3 allows debugging and programming of PIC and dsPIC Flash microcontrollers at a reasonable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a high speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming.
-Minimum of additional hardware needed for debug
-Expensive sockets or adapters are not required. The PICkit 3 can now also reprogram any PIC microcontroller.
Note: The PICkit 3 In-Circuit Debugger/Programmer is NOT a production programmer. It should be used for development purposes only.
---USB (High speed 12 Mbits/s interface to host PC)
---MPLAB IDE compatible (free copy included)
---Built-in over-voltage/short circuit monitor
---Firmware upgradeable from PC/web download
---Supports low voltage to 2.0 volts (2.0v to 6.0v range)
---Diagnostic LEDs (power, busy, error)
---Read/write program and data memory of microcontroller
---Erase of program memory space with verification
---Freeze-peripherals at breakpoint
---Program up to 512K byte flash with the Programmer-to-Go
One PIC kit3 programmer host
One red USB cable
One 6-pin ICSP cable
One universal 40-pin ZIF Socket
One offline power supply (5V, 1000mA )
One DVD disk