Home > All Categories > Consumer Electronics > Home Electronic Accessories >

Remote Controls

DOORHAN Replacement Rolling Code Remote Control Transmitter Gate Key Fob with battery high quality

US $1.42 - 5.22
US $1.50 - 5.50 -5%

Buyer Protection

Money Back Guarantee Refund in 15 Days

PRODUCT DETAILS

Item specifics

  • Brand Name: Scimagic-RC
  • Use: Electric Door
  • Use: Automated curtains
  • Use: Switch
  • Use: Universal
  • Wireless Communication: RF
  • Model Number: SMG-015
  • Channel: 4
  • Support APP: No
  • Package: Yes
  • Frequency: 433MHZ
  • frequency: 433.92MHz
  • Chip: Rolling code
  • Material: metal and PVC
  • Buttons: 4
  • Use: Electric Door,Universal Swing Gates
  • compatible 4: Doorhan Transmitter 2
  • compatible 3: Doorhan remote control
  • compatible: 433mhz Remote Control
  • compatible 5: Doorhan Transmitter 2
  • compatible 6: Doorhan Transmitter 4
Product Description

Compatible:

Brand new modern, stylish, compact design which fits perfectly in your pocket. The new design includes a sliding cover, preventing buttons being pressed accidently. Features: LED Indicator Sliding cover Compact pocket sized Dimensions: 7x 2.5 x 1cm(L X W X H) Included key ring Compatible: Doorhan Transmitter 2 Doorhan Transmitter 4

Programming / Learning Instructions:

Program to Gate / Garage Door Openers the same way as original DOORHAN Transmitter 4 remotes, please refer to your receiver's user manual. For a typical DOORHAN Garage Control Panel, the programming procedure is as follows: 1. Press and release the button R on the receiver. 2. The left side of display panel will show 0 then disappears immediately. 3. Press any button twice, coding is completed. 4. Press the transmitter button to test operation. Note: To remove a single transmitter's code or all transmitter codes from the receiver memory please refer to your receiver manual. Delete All Codes 1. Turn on the power to DHRE-2 receiver unit. 2. Press CODE button for 10 seconds CODE1 (or SW1) - if you are using CH1, CODE2 (or SW2) - if you are using CH2. 3. LED1 will be flashing 10 seconds then switch off for 2 seconds and flash twice to confirm that the memory is clear. 4. Release the button. All the stored codes including the courtesy light codes should now be deleted. Confirm this by pressing the transmitters previously used to operate the device. There should be no response.

YOU MAY ALSO LIKE