Home > All Categories > Electronic Components & Supplies > Active Components >

Integrated Circuits

18650 Battery Shield V3 For Raspberry Pi WEMOS ESP32 ESP32S For Arduino Micro USB Type-A USB Output Diy Kit

US $0.69 - 3.95

Buyer Protection

Money Back Guarantee Refund in 15 Days


Item specifics

  • Brand Name: EDIY
  • Type: Voltage Regulator
  • Condition: New
  • is_customized: yes
  • application: other
  • model number: module
  • supply voltage: international standard
  • dissipation power: international standard
  • operating temperature: international standard
Product Description

Battery protection(Over charge or Over discharge)
Micro USB port Input
Type-A USB Output
0.5A current charging
1 Switch control USB output
5~8V Input Voltage
3V & 1A Output
5V & 2A Output
LED indicate(Green means full,Red means charging)
3V output port x3
5V output port x3
Be careful of "+" and "-", You should follow the direction of "+""-" on the PCB.
Size: 9.8x2.9cm/3.86x1.14inch

1.Please allow 1-5mm error due to manual measurement. pls make sure you do not mind before you bid.
2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!
3. If you put wrong direction, charging chip will be destroyed.
4.This product does not include 18650 battery

Package include:
1 x Battery Shield Module ( Battery Not Included )




18650 shield has a strong ability for 18650 battery charging and discharging. It will be very helpful for a lot of projects.
It is a better solution than 18650 shield V1 which could charge and discharge at 3A. It also has 4 LEDs to show the charging status and dump energy. It could detect target when the output current is less than 30mA the board will shut off automatically. The sleeping current is only 6 uA.

When you click once the button, charging work will start and LEDs will show the dump energy. When you keep clicking the button over 2.5s,
output will stop..


Over charging protection
Over discharging protection
4 LEDs indication
Temperature protection
Battery short protection
Click button will start work
Clikc button 2.5s will stop output go to sleep mode.
If output Current of sleep mode is 6uA.
Efficiency is 93.5%
Work temperature: -40C~85C
Be careful of "+" and "-", You should follow the direction of "+""-" on the PCB.

Package included:

1 x Wemos® 18650 Battery Shield Expansion Board( 18650 battery not included)



< More For Arduino module please click the link> 


For Wemos D1 Mini 

For Raspberry Pi 3    ESP32   Breadboard  

Temperature Thermostat   Nodemcu  


>> To our store